
U-Line Self-Closing Door Alignment and Reversal 17
Reversing Stainless Steel Glass Doors
Remove Door
1. Hold door to keep it from falling.
2. Remove hinge screw pin (1) from top hinge using a Phillips
screwdriver.
3. Remove door by tilting forward and lifting door off bottom hinge
closer inserts.
4. Reinstall hinge screw pin (1) into top hinge using a Phillips
screwdriver.
Remove hole plugs.
1.
Remove plastic screw plugs from (three each, top and bottom)
(3)
from new hinge location. Save for reinstallation later.
Remove Stainless Frame
1. Remove two screws from top of door. Save screws for later
installation.
2. Remove pivot plate from bottom of door by removing 2 screws.
Set pivot plate and screws aside for later installation.
3. Grasp outer edge of stainless frame and firmly press inside edge
of glass in while pulling stainless frame in opposite direction.
4. Unhinge frame from door.
Assemble Stainless Frame
1. Prop frame against solid surface, handle side down and away
2. Insert door, logo forward, into frame at a 30° angle. For a right
hand hinge the logo should be to your right. For a left hand hinge
the logo should be to your left.
2
Pivot Plate
Screws
Bottom Of Door
Push Glass
In
Pull Frame
Away
Door Orientation Right Hand Hinge
Logo
Door Orientation Left Hand Hinge
Logo
Kommentare zu diesen Handbüchern