U-Line CLR60 Wartungshandbuch PDF herunterladen (Seite 10)

Service and Parts Manual

The objective of this section is to assist the

service technician in diagnosing problems that

are related to installation and/or leveling.

It is extremely important that the unit is level.

If it is not level, the ice mold will not fill evenly.

This can cause a reduction in ice rate, uneven

sized cubes or water spilling into the storage

area which will cause the ice in the bin to melt

prematurely. See Figure A.

Remember that floors near drains have a ten-

dency to slope towards the drain.

Leveling the Unit

1. Use a level to check the levelness of the icemaker from

front to back and from side to side. See Figure B.

2. If the icemaker is not level, adjust the feet on the cor-

ners of the unit as necessary. See Figure C.

3. Check the

levelness

after each

adjustment

and repeat

the previ-

ous steps

as neces-

sary until

the unit is

level.

Installation Requirements

• The unit may be built into a cabinet. There is no minimum clearance requirement for

the top, left or right sides of the unit.

• The location must allow enough clearance for water, drain, and electrical connections

in the rear of the unit.

• The location must not obstruct air flow to the front of the unit.

UL205

TURN FOOT TO ADJUST

UL215

UL307

LEVELING AND INSTALLATION REQUIREMENTS

Figure A

Figure B

Figure C

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

U-Line CLR60 Wartungshandbuch Seite 10